Adata ATX H-264 Manual de usuario Pagina 1

16CH H.264 Embedded Digital Video Recording systems  USER MANUAL 2012 DEC V1.2 

7Setup3: Setup recording quality / resolution / frame (as below), finish setup and then click「Next」for next step setting. Setup4: HDD management &am

86. System Operation There are 3 kinds of DVR control method: Front panel, remote control and USB mouse, The front panel operation, please refer to t

9Note：There are many DVR equipments in the same place, the remote control first need to select a device, according to the DVR ID. So, should give eac

10 Quick Menu The function described as below Enter the main menu For Single channel display For Quad Display (1-4),Click again and then displ

117. Display mode There are 4 kinds of screen display mode: Live, Auto Switch , PTZ , Digital zoom, quick playback. 7.1 Live Viewing Mod  The DVR

12Start/Stop the Manual record [Record] to enter manual menu to select Move cursor to UI Quick Menu [Left click] to select Start/Stop the Auto Swit

13 The following table is simple operation for Mouse and panel , remote control: Setup Operation Front Panel & Remote Control USB Mouse Select

147.4 Digital Zoom  This system provides digital zoom in or zoom out the video image on the live monitoring and playback interfaces.  Please oper

154. Moving mouse cursor to the bottom right corner of the selection area, press and hold the left mouse button drag to display the zoom position.

16 The playback operation control bar(as below), the function operation as follows: Menu Operation Front Panel & Remote Control USB Mouse Fas

ii WARNING  Do not expose the DVR under the sunlight, heat or wet environment while installation. As it could decrease the performance of DVR and

178. Menu Operation 8.1 User Login  After system turn on, the system will auto appear the following dialog box that you need to key in correct user

188.2 The Main Menu Instructions 8.2.1 Configuration Management  Path: Main Menu->Set up Management The setup management page is divided i

19( 1 ) Basic Setup  Path: Main Menu->Config management->Basic setup The setup page is divided into the System and Date & Time setup p

20 Note: If the setup is different the actual display, and then unable enter the menu to change the output screen. The system boot and plug to contin

21( 2 ) Live (Live image)  Path: Select Main menu->Configuration Management->Live. The setting page is divided into Live image and Mast(

22The mask setting steps are as follows, need to use the mouse set up: a. Select channel for privacy mask , click「Setup」, enter the live monitor sc

23record with image record. (The factory default for channel image record is enable; Audio record is closed) (3.2)Video record Bitrate The relat

24sampling rate. When the video is complex, the captured bit and retrieved bit are more, that will make the video data files increase. On the contrar

25(3.5)Loop Record Set up Loop record when the HDD is recording full to cover and Loop record. ( 4 ) Schedule Recording  Path: Main menu->Conf

26※ This DVR can setup image individually for each channel, the users setup need to pay attention(Avoid to only set up CH1 and forget to set up oth

iiiCONTENTS 1. Specification ...

27( 5 ) Alarm  Path: Select Main menu->Configuration management->Alarm  All Alarm setup for this DVR are all concentrated on this page, the

28 This setup can produce relevant action for the alarm is triggered, first set up the delay time. Alarm: Please press “Setting” for relative setup

29(5.1.2.2) Alarm Handling Select which camera to start recording after triggering the alarm (You can choose numerous or all) (5.1.2.3) To PTZ To s

30 (5.2) Motion Detection (5.2.1) Movement Detection a. Turn on the motion detection of designated camera b. The setting of continuous duration t

31 The display of remote control: Sensitivity Setting of Motion Detection, Using mouse to drag the area (Option 1 to 5, 5 is the highest) Select Wh

32(5.4) Alarm Output Main setting of alarm output (As figure 1.), Schedule (Please refer to Main Menu->Setting Management->Schedule Recording S

33Static IP Setting a. IP Address b. Subnet Mask c. Gateway d. DNS Server 1 e. DNS Server 2 PPPOE (As the following figure) a. PPPOE Setting

34 (6.3) E-mail Setting of Triggering Alarm Message Sending a. SMTP Server/Port: Input SMTP Server Name and Port b. Sender Address/Password: Setti

35 DDNS Setting: only for applier a. DDNS: On/Off b. DDNS Server c. DDNS User Name and Password d. Host Domain Name e. Update Interval (Minutes

36 The higher safety function is provided by this DVR by locking up with MAC address, and this means the only MAC address setup user is authorized. (

11. Specification Item Specification Main Chip Hi3520(ARM1176/600MHz) Operating System Embedded Linux Video Input Number of Video Input 16CH/BN

37(8.2) Advanced Setup PTZ Preset setup, cruise setup (default setup as cruise), and record track setup ( 9 ) Advance  Main Menu-> Setup Manage

38 8.2.2 Data Search  Main Menu-> Data Search Beside pressing quick menu button to playback daily 1~4 channel video files, you can also go

39( 2 ) By Type (Data Search Playback) As per multiple triggering recording is provided, user can search video recording type by the following ste

40 1. Select start and end time 2. Select channel 3. Press “Search” to list out all the search data 4. Select the data for backup “Available for mult

41 ( 1 ) System  Main Menu-> Information Search->System (or Press “Info” in the remote control)  Display system hard drive and software in

42 Steps: a. Select Time b. Type: Operation, Setup, Playback, Backup, Search, Information, Error; multiple selection is available. c. Press “Se

43 8.2.5 Hard Disk  Main Menu-> HDD Management  Displaying of HDD Status, users can format HDD in this function  Format Steps as following

44 Steps of Update Procedure: a. Select Type: Mainboard, Panel (for specific model), Boot logo, Show logo b. Select the update data; the update d

459. DVR Player  Back-up files playback, if backing up files with .ifv format, please use this player for playback.  DVR Player available are fro

46 2. Steps of capturing video clips as blow: a. Click “Control”->”Video Cut” as figure a. b. Move the mouse cursor to the designated timeline -

22. Structure of Product  Front Panel 0(+10)-9 Channel 1~16 Under the live viewing mode or playback mode, press channel 1~16 button to display

47 Picture 3 Picture 4

4810. IE Operation Instruction 10.1 IE Security setting: If it is the first time to connect DVR through IE, please refer to the following differen

493. Input the website or IP address which are designated to be connected, like http://122.117.84.239 as below, please let the box to remain unchecke

5010.2 IE ConnectionOpen IE and by entering IP address of the DVR to connect to the login screen as shown below. Select language you wish to view i

5110.2.1 The Main Screen Interface The main screen interface is shown as the following: video monitoring window, PTZ control, monitor split mode (si

5210.2.2 Remote Setting Configure (#8), modify DVR feature setting remotely as shown below: (a). system parameter settings: set or modify name of

53 (c). Alarm setting: set or modify the alarm input, output, etc... (d). User setting: set or modify users’ permissions and password.

54 (e). Other: manual recording, system time, alarm cancelling, event log, system reboot, remote updating, the factory default setting, remote video

5510.2.3 Remote Playback Playback (#9), time, motion, alarm, manual recording data playback or download. a. Channel selection b. Set the start, end

563. Click on monitoring window (red square will appear) and select a video file from the event log list on left you wish to playback. 4. Playba

3 Installation 1 Audio In 1~16 CH Audio input(RCA) 2 Audio Out Audio Output (RCA) 3 Video Out Video Output (BNC) 4 Line In Two-way Voice func

5710.2.4 Remote Monitoring Features On the main screen of remote monitoring, click on the channel (red box), right-click on the video monitoring wind

5811. Mobile Phone Software Installation Connect to DVR from mobile phone for remote live monitoring. Software applications which support Symbian, W

59

43. HDD Installation  Please install the 3.5 inch SATA HDD in the device and connect the power wire and transmission wire. If no install HDD, the s

54. System installation  Connect the camera video output to the DVR video input port with BNC connectors. BNC connectors recommend to use RG-59 o

65. Quick Set up Guide System power on, the system will automatically jump to quickly set up guided wizard and allows the user can simply and quickly