Adata SP300 Especificaciones descargar pdf (Pagina 30)

– 26 –

This printer can print one line of validation printing.

5-1. Operating Method

5. VALIDATION PRINTING (Models with validation function only)

Fig. 5-2 Loading the paper

1 Open the front cover, pull the adjust

lever one notch from standard posi-

tion A toward the operation panel

side position B.

When you cannot find standard po-

sition A, push the lever as far as

possible toward the rear cover, and

pull it 2 notches after having pressed

it down. The lever is now in standard

position A.

2 Mount the front cover.

3 Set the printer for the validation

print mode. In this instance, the

buzzer gives tow short beeps.

A: Standard position (one sheet)

B: Validation printing or copying

Adjust lever

4 Make sure that the ON LINE lamp

is flashing.

5 Align the right edge of paper with

the right end of the tear bar then

insert the paper from the top.

6 The printer starts printing approx. 1

second after the paper is loaded.

7 When printing is completed, pull

the paper upward and remove it

from the printer.

Note: When printing a roll paper, also

set the adjust lever at position B.

Fig. 5-1 Position of the adjust lever

POWER

ALARM

ON LINE

FEED

Rear cover

Front cover

Right end

of the tear bar

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 69 70

Sin comentarios

Adata SP300 Especificaciones Pagina 30